Roll it Device

Roll it Device is the first in-ear headset in combination with a rolling mechanism.

Available at your mobile phone specialist in the following countries:

Belgium, the Netherlands, Belgium, Great Britain, France, Spain, Italy, Greece, Germany, Poland, Russia, United States, Canada, UAE

worldwide pantent pending + model protection

New!

The use of the new earphone is very easy.
 
You take the ear between your fingers,  unroll the system and you can use it as a normal earphone.

You can also adjust the distance between the rolling mechanism and the plug-in.
Advantages of this new very handy device

Compared to existing wired earphones

-          No more problems with entangled wires
-          The set can be connected to your mobile phone
-          More value for money

Compared to wireless systems

-          No more dead batteries
-          Anyone can use it
-          No radiation in the ear
-          Much cheaper to buy
-          The set can be connected to your mobile phone
-          More reliable
-          Environmentally friendly
-          In many cases much better connection quality


Available for Nokia, Samsung, Ericsson-Sony, LG, I-Phone, Motorola and HTC

1. How do I roll back the cable?

By fully extending the cable and releasing it to return to its original position(clip at movies)

2. What if the cable doubles up and does not return to its original position?

Extend the cable to its full length and check that it is not doubled up. Allow the system to roll up the cable. If not immediately successful, repeat as needed. (clip at movies)

3. What if the cable between the rolling mechanism and the connector is too long or too short?

This is very easy to adjust. Extend the cable to its full length and move the rolling mechanism to the correct length. (clip at movies)

4. Does the magnet fixed to the mobile phone affect the phone’s battery?

Since a static magnet is used, it has no influence whatsoever.

Instructions

1.       Remove the paper from the magnet
2.       Fix the magnet to the back of the mobile phone
3.       Place the earphone on the back of the phone
4.       Plug the connector into the headphone jack on the phone 

To use the Rith

5.       Keep the connector in place with your finger or thumb
6.       Take the Rith by the earplug, pull away from the magnet and unroll the cable in a single motion
7.       Insert the earphone in your ear, activate the phone and you are ready to make/receive calls
8.       In order to return the earphone to its original position, pull out the full length of the cable and it will roll up again.